Cyclades AlterPath BladeManager Manuel d'instructions télécharger pdf (Page 94)

80 MergePoint 5224/5240 Service Processor Manager Installer and Administrator Guide

To add a target device:

1. Select the Config

- Target devices menu option.

2. Click the Add new target device button.

3. Enter a descriptive name for a service processor or other type of target device in the

Name field.

4. Enter the username and password pair used for logging into the device in the Login and

Password fields and retype the password to verify.

5. If target device groups have been configured, select the device group from the Target device

group pull

-down menu.

6. Select a group from the Target device group pull

-down menu if desired.

NOTE: For how to add a target device group, see To configure device groups: on page 83.

7. Select the target device type from the Type pull-down menu.

8. Select a data buffering option, Yes, No or Default from the Data buffering pull

-down menu.

9. Select a private subnet name from the Private subnet pull

-down menu.

NOTE: For how to configure private subnets, see To configure a private subnet: on page 106.

10. Enter the real IP address for the device in the Target Device IP address field.

11. If a virtual network has been configured as described in Configuring virtual networks (DNAT)

on page 52, enter a virtual IP address for the device in the Virtual IP address field.

12. Enter a description in the Description field.

13. Select an authentication type from the Authentication type pull

-down menu.

14. Select Yes or No from the Multisession pull

-down menu (applies to SoL access only).

15. Click OK.

16. Click Save and apply changes.

Configuring Target Device Types

By selecting the Config - Target device types menu option, the administrative user can configure

new target device types. A new target device type may be needed if a target SP does not work

properly with any of the default types. New target device types are defined using the parameters

and values described in Table 4.16 on page 49.

A new target device type may be configured in the following way on this screen.

• Start with one of the default types, and make modifications.

• Create a new target device template and then assign it to the SP.

One of the options is to change from Telnet to SSH as the connection protocol for communications

with the target device type, which is done by selecting ssh from the Protocol pull

-down menu.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 239 240

Pas de commentaire

Cyclades AlterPath BladeManager Manuel d'instructions Page 94