Cyclades AlterPath BladeManager Manuel d'instructions télécharger pdf (Page 31)

CHAPTER

Advanced Installation Topics

and

Tasks

Installing PC Cards in the Front Card Slots

Two PC cards of different types can be installed in any order. Two PC cards of the same type,

however, must be installed with the card in slot 1 configured first, followed by the card in slot 2.

To avoid the risk that swapping in a new PC card may result in the configuration being lost on one

or both of the cards, follow the procedure under To swap in a new PC card: on page 17 to remove

any existing cards then insert and configure the new card before reinserting and reconfiguring the

old card. Supported cards are listed at: http://www.avocent.com on the product page.

To install a PC card:

NOTE: Some cards take up both card slots.

1. Insert a PC card into a front slot(s) and slide the card in until it is firmly seated.

2. Use the Web Manager

- Settings - PCMCIA form to configure the PC card.

a. Click the Insert button on the form next to the number of the slot where the card

is installed. A prompt displays asking if you have inserted the card into the slot.

b. Click Yes.

c. Click the Configure button. A PC card configuration form appears.

d. Select a card type from the Card Type pull

-down menu. Fill out the fields and select

among the choices on the menus.

To remove a PC card:

1. On the Web Manager

- Settings - PCMCIA form, select the Eject button next to the card’s

slot number.

2. On the front of the SP manager, press the button next to the slot.

3. Remove the card from the slot.

To swap in a new PC card:

Complete the following steps if only one card slot is in use, you wish to replace the current card (or

add a new one) and the new card is the same as the one already installed.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 239 240

Pas de commentaire

Cyclades AlterPath BladeManager Manuel d'instructions Page 31