Cyclades AlterPath OnBoard Informations techniques télécharger pdf (Page 346)

100

101

cycli Parameters and Arguments

306 AlterPath OnBoard Administrator’s Guide

etc/param.conf file. Table 10-2 on page 313 shows branches of the tree that let

you add parameters to them.

The following diagram illustrates one parameter in the OnBoard cycli

parameter tree. As shown in the example in Figure 10-1, each branch in the

parameter tree is made up of one or more parameters, one nested below the

other. In the figure, the top-level network parameter is followed by the

second-level interface parameter, which is then followed by the third-

level failover parameter. No parameters are nested under failover.

Figure 10-1:Example Branch in the cycli Parameter Tree

In this branch the only commands supported are “get” and set.” All of the

parameters in a branch are entered together on a single cycli command line.

For example, to get the value set for failover, you would enter:

Entering “set” with “yes” enables Ethernet failover; “no” disables it. To set failover, you

would enter the following command in interactive mode:

You can use autocompletion with the set command to find out the accepted

values.

cli> get network interface failover

cli>

cli> set network interface failover

yes

cli>

cli> set network interface failover <Tab><Tab>

set to yes or no. Enables or disables the interface bond0.

cli>

network

interface

failover

1 2 ... 341 342 343 344 345 346 347 348 349 350 351 ... 501 502

Commentaires sur ces manuels

Pas de commentaire

Cyclades AlterPath OnBoard Informations techniques Page 346

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Cyclades AlterPath OnBoard