Cyclades AlterPath OnBoard Guide d'installation télécharger pdf (Page 61)

Installation 45

Connecting One or More IPDUs to the AUX Port

If you are daisy-chaining additional PMs, go to “To Daisy-Chain

AlterPath PMs to the OnBoard” on page 45.

3. Configure the AUX port for Power Management.

See the AlterPath OnBoard Administrator’s Guide for details about

configuring the AUX port.

T To Daisy-Chain AlterPath PMs to the

OnBoard

This procedure assumes that one AlterPath PM is connected to the AUX port

on the OnBoard. You need a straight-through RJ-45 to RJ-45 CAT5 or greater

cable for each AlterPath IPDU PM you will be connecting.

1. Connect one end of a CAT5 cable to the “Out” port of a AlterPath PM that

is already connected to the AUX port of a OnBoard.

2. Connect the other end of the CAT5 cable to the “In” port of the next

AlterPath PM.

3. Repeat Steps 1 and 2 until you have connected the desired number of

AlterPath PMs.

4. Configure the AUX port for Power Management.

See the AlterPath OnBoard Administrator’s Guide for details about

configuring the AUX port, and for how to make sure that all daisy-chained

PMs are running the same firmware version.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 103 104

Pas de commentaire

Cyclades AlterPath OnBoard Guide d'installation Page 61